• Defence
  • Interiors
  • Aerospace
  • Automotive
  • Architectural
  • Brass
  • Glass
  • Foam
  • Rubber
  • Gasket
  • Marble
  • Copper
  • Granite
  • Carbide
  • Steel (SS)
  • Ceramics
  • Aluminium
  • Mild Steel (MS)
  • Composites (ACP)

“Much better than lasers for cutting reflective mediums and again with no heat stress There are many applications where abrasive JetAxis cutting technology is the cutting method of choice. JetAxis is an excellent choice when cutting thick materials, where laser cutting is ideal for thin steels.”

Our ultra-high pressure JetAxis uses water compressed up to 60,000 psi and generates jet stream that is capable of cutting material from. 001 thick up to 8 inches thick Our abrasive JetAxis can pierce or drill holes as small as .030” in diameter

There are many advantages of JetAxis cutting. As opposed to flame, plasma & laser cutting, JetAxis and abrasive jet cutting produce no heat affected zone to work harden the cut edges. Therefore you are able to cut various metals, plastics and other materials without melting, distorting or warping them.

No Heat Build-up. 
Materials like glass, rubber, and plastic will not melt during the cutting process. No melting, no heat affected areas, no structural changes.

Cuts just about anything. 
JetAxis machining is capable of cutting just about anything.

Less Waste. 
"Parts nesting" provides optimum use of sheet materials, reducing scrap.

The JetAxis cutting process involves no chemicals, gases or noxious liquids. Abrasive JetAxis cutting uses garnet (a high grade sand) as the abrasive. This creates a very clean process, preferable to other methods of cutting in terms of environmental impact, eliminating disposal of by-products and waste water. There is no dust created when cutting stone with JetAxis technology, thus providing a safer work environment for those using JetAxis to cut stone inlays and countertops